Multivitamin Gummies: Twelve Actives in One Chew

A multivitamin is not one formulation, it is twelve stability profiles fighting for the same 2 g of solids. We set the overage per nutrient from measured retention, drop what a gummy cannot hold, and print a label you can defend after six months on a shelf.

10-13
Vitamins per formula
2 Pieces
Standard serving
3,000 Units
Minimum per SKU
Multivitamin Gummies: Twelve Actives in One Chew

Why Multivitamin Gummies Lose Potency Unevenly

Each vitamin degrades at a different rate through the same cook. Vitamin C and thiamine are the fastest losers, riboflavin and niacin are stable, vitamin A palmitate is light-sensitive, and folic acid sits in the middle. A single blanket overage of 20% therefore over-doses the stable nutrients and under-doses the fragile ones, and the label fails at month nine on the two that matter.

The practical fix is a per-nutrient overage built from retention data on your base and your process temperature. We assay the finished piece at 0 and 3 months during the pilot, then set the input so the label claim still holds at the end of shelf life.

What does not go in: iron, for the same taste and oxidation reasons as prenatal, and often calcium and magnesium at meaningful doses, because the grams are simply not there. Those move to a companion tablet or powder, and the gummy stays a vitamin product rather than pretending to be a mineral one.

What Our Multivitamin Gummy Line Covers

Per-Nutrient Overage
Retention measured for each vitamin on your base, then the input set so the claim survives 12-18 months at 25 °C.
Formula Design
Adult, senior, kids and sugar-free versions with 10-13 vitamins, plus optional zinc, biotin and choline where the solids allow.
Sensory Balance
B vitamins taste bitter and yeasty at dose, so the acid system and masking are tuned around the B complex rather than around sugar alone.
Label Maths
Percent daily value calculated against the correct reference for the market, with rounding checked before artwork goes to print.

Multivitamin Gummy Capability

ParameterRangeNotes
Vitamins per formula10-13A, C, D3, E, B1, B2, B3, B5, B6, B12, folate, biotin
Serving size2 gummies2.5-3 g per piece
Vitamin C60-250 mg per servingSodium ascorbate reduces acidity
Vitamin D3400-2,000 IUPowder or emulsified
BasePectin, gelatin or sugar-free polyolPolyol systems need water activity control
Batch size50,000-2,000,000 gummiesPilot runs from 3,000 units

From Brief to Finished Multivitamin Gummy

01
Label and Nutrient Review
We check the nutrient list, the reference values and the serving size before deciding what fits.
02
Retention Trial
A pilot cook measures how much of each vitamin survives deposit and curing on your chosen base.
03
Overage Calculation
Input levels are set per nutrient from the measured retention, with the shelf-life target built in.
04
Stability
Samples at 25 °C and 40 °C, full panel assay at 0, 1, 3 and 6 months.
05
Production
Cooking, depositing, curing and polishing under GMP, with metal detection on every lot.
06
Testing and Packing
Full finished-piece assay, micro and heavy metals, then packing to your artwork.

Quality Control for Multivitamin Gummies

The finished-piece assay is the only number that matters, and for a multivitamin it means a full panel rather than a spot check: C, B1, B2, B3, B5, B6, B12, folate, A, D, E and biotin, each against its own specification. Batches that pass on average but fail one nutrient are the usual failure mode.

Production runs under GMP with ISO 9001, ISO 22000 and HACCP; the facility is registered with the US FDA as a food facility and holds Halal certification. Third-party verification of the full panel is available for each batch.

GMPISO 9001ISO 22000HACCPFDA-registered facilityHalal

Multivitamin Gummy FAQ

How many vitamins fit in a gummy?+
Ten to thirteen in a two-piece serving at typical retail doses. The limit is solids and taste rather than chemistry: B vitamins turn bitter and the piece stops being pleasant above a certain load.
Why is there no iron in most multivitamin gummies?+
Taste and oxidation. Iron reads metallic in a fruit chew and accelerates colour drift, so it moves to a separate tablet or softgel.
How do you stop potency dropping over shelf life?+
By measuring retention per vitamin on your base and overaging each input individually. A blanket overage over-doses the stable vitamins and still fails on vitamin C and thiamine.
Can it be sugar-free?+
Yes, with maltitol, erythritol or allulose systems. Polyols change water activity and texture, so the base is tested rather than substituted one for one.
Is a kids version different?+
Yes: 400 IU vitamin D3, 15-25 mg vitamin C, no iron, smaller 2-2.5 g pieces, and no polyol sweeteners because of gastrointestinal tolerance in young children.
How is the daily value calculated?+
Against the reference intake for the target market, with the rounding rules applied before artwork. US and EU values differ, so the same formula can print two different labels.
What is the minimum order?+
3,000 finished units per SKU for a pilot, with volume pricing from 50,000 gummies per batch.
How long does production take?+
Four to six weeks after artwork and materials are approved, plus seven to ten days for samples.

Send Your Multivitamin Gummy Brief

Send the nutrient list and the market you are labelling for. We will return a feasibility table showing what fits in two pieces, what needs an overage, and what should move to a companion product.

Related Pages